Planning Jet-Vac pool cleaner plumbing before concreting? Aqua-Quip helps pool owners and builders Australia-wide and overseas specify the setup early.
Decisions about Jet-Vac pool cleaner plumbing should be made before a concrete pool shell and surrounding surfaces are completed. Jet-Vac needs a dedicated pressure line, so delaying the decision until handover can make the required alterations more disruptive. We recommend coordinating the provision with the pool builder while the shell plumbing remains accessible.
What Plumbing Does a Jet-Vac Cleaner Need?
Jet-Vac requires a dedicated line from its booster pump to a threaded connection in the pool wall. Filtered water travels through the line, wall fitting, and feed hose, supplying the pressure that propels the cleaner and creates the venturi action used to collect debris.
Most installations use a 40 mm, 1½-inch female-threaded wall provision, while an adaptor is available for a 19 mm, ¾-inch provision. The connection must be positioned so the feed hose can reach the furthest point of the pool. Our Jet-Vac automatic pool cleaner is a mobile pressure cleaner connected at the wall, not an in-floor cleaning system.
Why Should the Line Be Installed Before Concreting?
Pool plumbing is normally positioned before concrete, or shotcrete forms the completed shell. Once the dedicated line and wall penetration are concealed, adding or changing them may require cutting, excavation, or alterations to finished surfaces, depending on the pool design and available access.
Early coordination also gives the builder clear specifications before structural work proceeds. Swimming Pool and Spa Association guidance explains that pool approval documentation generally includes detailed plans and specifications addressing water recirculation and relevant technical requirements. This guidance does not require Jet-Vac, but it reinforces the value of resolving pool equipment requirements during design.
What Should Be Confirmed Before Pool Handover?
Before the shell is completed, the Jet-Vac pool cleaner plumbing should be checked against our current installation instructions. A vague cleaner allowance may not provide the correct wall connection, booster pump arrangement, or feed-hose coverage. Owners and builders should confirm the following items:
- Dedicated line: Confirm the supply line reaches the selected wall-fitting position.
- Wall provision: Check that its female thread suits the Jet-Vac wall adaptor.
- Equipment area: Allow suitable space for the Aqua-Quip booster pump and controls.
- Pump sequence: Install the booster pump after the filter and before chlorination equipment.
- Operating controls: Prevent the booster pump from running unless the main pool pump is operating.
- Testing: Flush, pressure-test, and label the dedicated line before concealing it.
A licensed electrician should complete all electrical connections, and the pool must be manually vacuumed before Jet-Vac installation to remove damaging construction debris. Once commissioned, Jet-Vac typically runs for two to three hours daily, collecting up to 3.5 litres of leaves, twigs and dirt in its bag. Automatic forward and reverse cycles help it move away from corners and obstructions.
Aqua-Quip Support for Jet-Vac Pool Cleaner Plumbing
Early specification preserves the cleaner option before permanent structures restrict access. At Aqua-Quip, we provide current product information and installation instructions so owners and pool professionals can coordinate the wall fitting, dedicated line, and booster pump. Confirming these requirements before concreting reduces avoidable alterations and supports correct commissioning.
Contact us for current Jet-Vac installation information to provide to your pool builder before plumbing rough-in is completed.
